Kodak HR User Manual page 42

Validating the Scanner
3-10
b. Enter the Channel information:
• Set the Count to 3.
• Make sure Interleaved is selected.
• Set Depth to 16 Bits.
• Set Byte Order to IBM PC.
3. Click OK.
After a few seconds, the raw image appears.
4. Select Image>Adjust>Auto Levels.
After a few seconds, a clearer image should appear.
5. Select Image>Rotate Canvas>Flip Vertical.
NOTE: You may also need to select Image>Rotate Canvas>90° CCW.
6. Check that the image appears as you expected.
7. If the image does not appear as you expected, repeat this procedure, making
sure you follow the instructions exactly. Then if you still do not get the
expected results, contact your Kodak representative.
May 2002