Kodak HR User Manual page 3

CAUTION: The HR Film Scanner weighs almost 120 lbs (54,5 kg). Two people are needed to safely lift the
scanner from the box.
The table for the scanner must be:
• stable
• able to support approximately 120 lbs (54,5 kg)
• at least 30 in. (76,2 cm) long x 30 in. (76,2 cm) wide
cutouts
May 2002
HR 500 Plus and Universal Film Scanners
lid
styrofoam
scanner in
plastic bag
styrofoam
under scanner
front
compartment
with
accessories
Unpacking Instructions for the
KODAK PROFESSIONAL
1. Inspect the box to make sure there is no damage.
If there is damage, contact the shipping company.
2. Remove the lid from the box.
3. Remove the scanner accessories (such as cables
and the SCSI board) from the front compartment of
the box.
4. Compare the packing list to the contents.
If there is an item missing:
• In the United States: call Eastman Kodak
Company at 1-800-822-1414.
• Outside the United States: contact your local
Kodak representative.
5. Open the plastic bag that covers the scanner and
move the bag to reach the cutouts in the styrofoam
under the scanner.
CAUTION: Two people are needed to lift the scanner
from the box.
6. Use the styrofoam cutouts to reach under the scanner
(one person in front; one person in back) and lift the
scanner from the box onto the table.
7. Keep the scanner packing material until you are
satisfied that the scanner is operating correctly.
CAUTION: The setting on the AC input module on
the back of the scanner must be
compatible with the power source.
iii