Explanation Of Measurement Modes - Omron ZX-GT User Manual

Explanation of Measurement Modes

Interrupted Beam Width Measurement Mode [DK.WID]
Note
In cases such as the following, the width of the first interrupted beam section is measured
from the side of the Sensor where the LED is located.
Incident Beam Width Measurement Mode [LT.WID]
Note
In cases such as the following, the width of the first incident beam section is measured from
the side of the Sensor where the LED is located.
52
Settings Matched to Specific Measurement Requirements
This mode is for measuring the width up to
the end of the first interrupted beam section.
How to select the measurement
mode p.44
SUB
This width is measured.
This mode is for measuring the width up to
the end of the first incident beam section.
How to select the measurement
mode p.44
SUB
This width is measured.
ZX-GT User's Manual