Connecting Controllers To Each Other - Omron ZX-GT User Manual

Connecting Controllers to Each Other

Controllers are connected to each other via a Calculating Unit.
The number of Controllers that can be connected to each other is as follows:
• When calculating Controller measured values: three Controllers
• When multiple points are measured and are collectively output from the Interface Unit:
2
Important
• Provide power to all connected Controllers.
• Connect the emitter sync wires to the respective Controllers.
• Wiring the Sensor (emitter) p.29
• Wiring the Controller p.30
ZX-GT User's Manual
Calculation can be performed on two of these
Controllers. (One of the calculation targets
must always be CH1.)
3 4
1
1
three Controllers or less
1
Open the Controller connector
cover by lifting and sliding it up.
2
Mount the Calculating Unit on a
DIN track.
3
Slide the Calculating Unit
and insert it into the connector on
the Controller.
4
Slide the Controller to insert it
into the connector
Calculating Unit.
Mounting and Connecting Devices
on the
37