Omron ZX-T Operation Manual page 75

Section 5
DETAILED SETTINGS
Selection
S-H (Sample hold)
PP-H (Peak-to-peak
hold)
SP-H (Self-peak hold)
SB-H (Self-bottom hold) Holds the minimum value during the sampling period. The sampling period is the
Hysteresis width (for self trigger)
Set the hysteresis based on fluctuations in the measured values around the trigger level. When set,
hysteresis will be applied from the start of the sampling period and will prevent timing input chatter-
ing.
ZX-T
72
Operation Manual
Holds the measured value the moment the timing signal turns ON.
ON
Timing input
OFF
Holds the difference between the maximum and minimum values during the
sampling period. The sampling period is the period that the timing signal is ON.
This option is selected mainly when detecting vibration.
ON
Timing input
OFF
Holds the maximum value during the sampling period. The sampling period is
the period when the measured value is greater than the specified trigger level.
Trigger level
Sampling period
period when the measured value is lower than the specified trigger level.
Trigger level
Details
Sampling period
Maximum value
Maximum
value
Minimum
Minimum
value
value
Sampling period
Maximum value
Minimum value
Sampling period
Output
(Changes the
moment the
sampling period
is entered.)
Output
(difference
between
maximum
and minimum)
Output
Hysteresis
width (for self
trigger)*
Operating value
Release value
Hysteresis
width (for self
trigger)*
Output
Operating value
Release value