Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 193

Data Input
Note
After creating touch switches (control code
input) or a system keypad on the same
screen (includes a keyboard window),
pressing the key allocated the control
code [1] enters [1] in the numeral setting
input field. If key [2] is then pressed, the
input field shows 12.
Press the
into the input field in the numeral memory
table.
It is possible to create a touch switch to which a cursor moving key is allocated
later.
Create Cursor Move Touch Switch
Specify whether or not a cursor moving touch switch is automatically created.
Settings may not be possible for some PT models.
Each time a numeral input or thumbwheel object is newly created, a numeral
table entry number (where input data is stored) is automatically set as 0 1 2...
incrementally (table entry number after the last set one will be the next default
number). A numeral table entry number can be changed by displaying the prop-
erty setting dialog box. (It is also possible to change it later.)
S A numeral input element itself creates a numeral setting input field. It is always
used with a control code inputting touch switch (control code input function) or
a system keypad. Data is input to a numeral setting input field using the control
code input touch switches and the system keypad that are displayed with the
numeral setting input field.
This data input field is created by a numeral
input element.
0 0 0 0 0 . 0 0
1 2
key to store the data input
S The procedure for creating a control code input touch switch is shown below.
(1) Set the control code input function for a touch switch.
(2) Select the code from the control code list.
The input field and the control code input touch
switch are automatically correlated. Carry over
is processed automatically.
Control code inputting Numeral setting
touch switch input field
Touch 1
Touch 2 12
Touch
12
Section 6-4
1
This is stored
in the memory
table.
177