Installing The Support Tool; Basic Installation Operation; Procedure - Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4 Operation Manual

Installing the Support Tool

2-2

Installing the Support Tool

Reference:

2-2-1 Basic Installation Operation

2-2-2 Procedure

To install the Support Tool, execute the install program provided in your software
package.
The following data is selectable for installation.
S NT-series Support Tool Ver. 4.j
S System Installer
S Sample Collection
If you select a Sample Collection, data such as Parts Collection, Image/Library
Sample Collection, ISO symbol data, and Sample Screen Data are installed.
S NT Transfer Utility should be installed separately. Please refer to Appendix C
NT Transfer Utility.
S NT Translation Support Utility should be installed separately. Refer to Appen-
dix D Translation Support Utility.
S Data can be added afterward by executing the installation program again. In
this case, when an item that is already installed is specified, it will not be over-
written. Also, the data will not be uninstalled even if its check mark was set to
OFF when the data is already installed.
To delete data that has already been installed, delete all data by uninstalling it
and then perform installation again.
The buttons that are displayed during the course of installation are shown below.
Clicking on this button confirms the settings in the displayed window and displays
the next window.
Clicking on this button cancels the settings in the displayed window and displays
the previous window.
Clicking on this button causes the window to close. The status set in the window
is canceled.
This button stops Support Tool installation if it is clicked at the program install win-
dow. In this case, a message is displayed requesting confirmation that installa-
tion is to be stopped.
Clicking on this button displays the actual folder configuration in tree form. You
can select the folder in this display to install the Support Tool.
The following procedure uses Support Tool version 4.8 as a example.
1. Start up Windows.
When using Windows 2000, Windows XP, Windows Vista, or Windows 7, log
in with a user ID in the administrators group.
2. Set the Support Tool CD-ROM in the CD-ROM drive. The setup program au-
tomatically starts. Follow step 6 onward. If the setup program does not start
automatically, execute the setup program according to the steps shown be-
low.
Section 2-2
31