Omron NT-SERIES - SUPPORT TOOL FOR WINDOWS V4 Operation Manual page 287

Common Operation
Operation procedure (search)
Operation procedure (replace)
When the specified data is found, the cursor in the table automatically moves to
the found table entry number.
Search for the next appearance by clicking on this button again.
Clicking this button starts replace processing.
The data specified for [Find What] is searched for and replaced with the data set
for [Replace With].
All appearances are replaced with the specified data at one time.
(1) Specify the table address (the start position of the search range).
(2) Click on .
(3) Select the objective of the search in the [Search By] box.
(4) Specify the search objective data in the [Find What] box.
(5) Click on
(1) Specify the table address (the start position of the replace range).
(2) Click on .
(3) Select the objective of replace in the [Search By] box.
(4) Specify the data to be replaced in the [Find What] box.
(5) Specify the data to replace the old data in the [Replace With] box.
.
Section 7-1
271