Operation Start: Os; Operation Stop: Op - Omron E5ZE-8 Communications Manual

Operation Start: OS

8-1 Operation Start: OS
Function
Command
@
x16
Response
Communications Example
Command
Response
8-2

Operation Stop: OP

Function
164
This command is used to designate a control point to start temperature con-
trol.
1. Operation Start (OS) cannot be used at a control point being auto - tuned.
2. Operation Start (OS) will be ignored by a control point in control operation.
Unit
O S
x16 0
1
Header code
@
Unit
x16 1
In this example, control point 3, the unit number of which has been set to 1,
starts temperature control with Operation Start (OS).
@ 0
@ 0 1
This command is used to designate a control point to stop temperature control
or manual operation.
If a control point is stopped, all alarm output of the control point will be OFF.
Always 0
Control
0 0
point
Data code
Always 0
O S
End code
x16 0 x16
Header code
1 O S 0 3
O S 0 0
Normal end
*
0
FCS
Terminator
FCS
1 0
x16
*
0 0 5 E
*
s
5 D
Section 8-1
s
*
s
Terminator
s