Measurement Values For Individual Control Points - Omron E5ZE-8 Communications Manual

DeviceNet Explicit Messages Set Values and Measurement
4-4-6

Measurement Values for Individual Control Points

Variable Type: 80
No. Address
measurement value
1 X001 Status (See note.)
2 X002 Heating output variable
3 X003 Heater current
4 X004 Cooling output variable
5 X005 Current set point
6 X006 Current memory bank
7 X007 SSR failure current value Range: 0000 to 0226 (0.0 to 55.0)
Status
Leftmost
Reserved for the system.
30
• Numeric values are expressed as 16 - bit signed binary (two ' s complement
for negative values).
Note 1. These parameters can be written while auto - tuning is being executed.
2. The following settings are not possible
Heating output variable lower limit > Heating output variable upper limit
Cooling output variable lower limit > Cooling output variable upper limit
3. The default is 0008 hexadecimal (0.8 C) when the temperature unit is de-
grees Celsius, and 000F hexadecimal (1.5 F) when it is degrees Fahren-
heit.
The following variable type is used to monitor various measurement values at
the same time for each control point.
Set value or
Range: 0000 to FFBF
Range: 0000 to 03EB (0.0 to 100.0)
Unit:
Range: 0000 to 0226 (0.0 to 55.0)
Unit:
Range: 0000 to 03EB (0.0 to 100.0)
Unit:
Depends on the input type, setting unit, and
temperature unit
Range: 0000 to 0007
Unit:
Set the value of X in the address to the applicable control point number (0 to
7).
Note The following diagram shows the status contents. Treat the bits specified as
reserved for the system as being any status.
Reserved for the system.
Always 0.
Data setting or monitoring range
0.1%
0.1%
0.1 A
Rightmost
Start/Stop (0: Stop, 1: Start)
RUN Status (0: Manual operation, 1: Temperature control)
Normal/Reverse Operation (0: Reverse, 1: Normal)
Reserved for the system.
Autotuning (0: Not executing, 1: Executing)
Section 4-4
Data type
Numeric
Read only