Using The Bed Support - Toro 07384 Operator's Manual

Using the Bed Support

Important:
Always install or remove the bed
support from the outside of the bed.
1. Raise the bed until the lift cylinders are fully
extended.
2. Remove the bed support from the storage
brackets on the back of the ROPS panel
21).
Figure 21
1. Bed support
3. Push the bed support onto the cylinder rod, and
ensure that the support-end tabs rest on the
end of the cylinder barrel and cylinder-rod end
(Figure 22).
(Figure
1. Bed support
2. Cylinder barrel
4. Remove the bed support from the cylinder, and
insert it into the brackets on the back of the
ROPS panel.
Important:
the bed-safety support on the cylinder.
g026142
33
Figure 22
3. Bed
Do not try to lower the bed with
g009164