Operation; Front Panel Buttons Operation - YOKOGAWA YPP6830-AP0-0 Instruction Manual

YPP6830 Explosion-Proof Pulse Input Rate/Totalizer

Operation

Front Panel Buttons Operation

Symbol Description
• Hold the Menu SafeTouch button when
in power save mode (display will show
) to awaken SafeTouch buttons.
• Press the Menu button to enter
Programming Mode.
• Press the Menu button during
Programming Mode to return to the
previous menu selections.
MENU • Hold the Menu button for 1.5 seconds at
any time to exit Programming Mode and
return to Run Mode.
• Press and hold the Menu button for 3
seconds to access the Advanced
Features of the meter.
• Press the Right arrow button to move to
the next digit or decimal position during
programming.
• Press Right to go forward through most
RESET
selection menus.
• Press Reset to reset the total, or values
displayed in the bottom display (grand
total, max, or min). Press Enter after
Reset to confirm the reset.
• Press Display when in Run Mode to
display the grand total, again to display
the maximum, and again to display the
minimum reading since last reset. These
displays will time out in 12 seconds, or
DISPLAY
press Display until total is displayed in
the lower display. Press Enter to lock
this display, and disable the 12 second
time out.
• Press the Up arrow button to scroll
forward through the menus, decimal
point, or to increment the value of a digit.
• Press the Enter button to access a menu
or to accept a setting.
• Press Enter to lock display of grand
total, Max or Min readings (disables 10
second timeout).
•
Press Enter while the grand total,
or min reading is locked on the lower
ENTER
display to return to run mode.
• Press Enter to acknowledge alarm (if
enabled).
•
The following SafeTouch button information is reprinted
from SafeTouch Button Operation on page 17.
SafeTouch Button Operation
To actuate a button, press and remove one finger to
the glass directly over the marked button area. Remove
finger to at least 4 inches away from the window in
between button activations. SafeTouch and mechanical
buttons may be held to cycle through menus or digits in
place of repeatedly pushing a button.
SafeTouch Power Save Mode
SafeTouch buttons enter a power saving mode after three
minutes of inactivity. This mode is indicated by the
SafeTouch power symbol (
right of the display. Only the MENU button is monitored in
this mode. To activate the SafeTouch buttons, press and
hold the menu button for up to five seconds. The display
will read AWAKE, and the SafeTouch buttons will be fully
enabled.
SafeTouch Disabled Mode
When the cover is removed, the four mechanical
buttons located next to the sensors may be used. The
sensors are disabled when a mechanical button is
pressed and will automatically be re-enabled after
60 seconds of inactivity. The SafeTouch power symbol (
) will blink in the lower right of the display if the
buttons are disabled due to a mechanical pushbutton
being pressed.
•
SafeTouch will not work if two or more buttons
are detected as being pressed simultaneously.
Be careful to avoid triggering multiple buttons or
reaching across one button location to press
another.
max,
46
Instruction Manual
) appearing in the lower