Buttons And Display - YOKOGAWA YPP6830-AP0-0 Instruction Manual

YPP6830 Explosion-Proof Pulse Input Rate/Totalizer

Buttons and Display

Button
Description
Symbol
Menu /
SafeTouc
h Awake
Right
RESET
Arrow /
Reset
Up
DISPLAY
Arrow /
Display
Enter /
Alarm
Ack
ENTER
Symbol Status
HI High Alarm
LO Low Alarm
SET Total Alarm
Settings
Lockout
Password
Enabled
SafeTouch
Power
Save/Disable.
Flashing:
Temporarily
Disabled Due
to Mechanical
Button
Total Display
Flashing: Total
T
Overflow
Indication
Grand Total
Display
GT
Flashing: Total
Overflow
Indication
13 Digit Total
Overflow, 6
Most Significant
Digits
Flashing: Low
Battery Indicator
BAT
Steady:
Powered by
Battery Backup
18
Menu Button
• Hold the Menu SafeTouch button when in
power save mode (display will show
awaken SafeTouch buttons.
• Press the Menu button to enter Programming
Mode.
• Press the Menu button during Programming
Mode to return to the previous menu
selections.
• Hold the Menu button for 1.5 seconds at any
time to exit Programming Mode and return to
Run Mode.
• Press and hold the Menu button for 3 seconds
to access the Advanced Features of the meter.
Right / Reset Button
• Press the Right arrow button to move to the
next digit or decimal position during
programming.
• Press Right to go forward through most
selection menus.
• Press Reset to reset the total, or values
displayed in the bottom display (grand total,
max, or min). Press Enter after Reset to
confirm the reset.
Up / Display Button
• Press Display when in Run Mode to display
the grand total, again to display the maximum,
and again to display the minimum reading
since last reset. These displays will time out in
12 seconds, or press Display until total is
displayed in the lower display. Press Enter to
lock this display, and disable the 12 second
time out.
• Press the Up arrow button to scroll forward
through the menus, decimal point, or to
increment the value of a digit.
Enter Button
• Press the Enter button to access a menu or to
accept a setting.
• Press Enter to lock display of grand total, Max
or Min readings (disables 10 second timeout).
• Press Enter while the grand total, max, or min
reading is locked on the lower display to return
to run mode.
• Press Enter to acknowledge alarm (if enabled).
Instruction Manual
) to