YPP6830 Explosion-Proof Pulse Input Rate/Totalizer
Battery Replacement
Battery-equipped models have a battery charge
monitor. When the battery is nearing the end of its
capacity the screen will periodically flash the message
LO BATTERY and the BAT indicator on the screen will
flash. The recommended replacement interval for
models using the battery as a primary power source is
determined by the power and feature use, as shown on
page 6. The battery should be replaced when the low
battery indication is on the screen.
The total is backed up in non-volatile memory when the
low battery monitor is tripped. It is recommended that
an updated reading be manually backed up prior to
changing out the battery.
•
Fire, explosion, and burns may result if not
handled properly. Do not recharge, short circuit,
crush, disassemble, heat above 100°C (212°F),
incinerate, or expose contents to water.
•
Battery disposal should be in accordance with
applicable regulations, which vary by location. In
many locations trashing of used batteries is
forbidden and disposal is done through local
battery disposal facilities. Spent batteries should
be packaged in such a way as to prevent short
circuits during handling and transport.
NOTICE: Battery may only be replaced with an original
Model
YPPABAT36C
supplied by Yokogawa. Do not
recharge battery. Do not replace with used battery.
• Remove cover and display module and disconnect
display module ribbon cable.
• Carefully cut and remove the cable ties supplied
for shipping (if present).
• Remove the spent battery and prepare it for
disposal.
• Install new YPPABAT36C into battery clip with
polarity as shown in Figure 17.
• Reconnect and fasten display module. Install
enclosure cover.
• Resume operation.
Figure 17. Battery Orientation
Setup and Programming
There is no need to recalibrate the meter for frequency
in Hz when first received from the factory.
The meter is factory calibrated for Hz prior to shipment.
The calibration equipment is traceable to NIST standards.
Overview
Setup and programming is done through the infrared
through-glass SafeTouch buttons, using the
mechanical buttons when uncovered, or with
PROPLUS EX programming software. There are two
slide switches located on the display module. One is
used to configure the input and the other is to lock or
unlock the SafeTouch Buttons.
PROPLUS EX Programming
Software
The fastest and easiest way to program the meter is
using the free PROPLUS EX programming software.
This software greatly simplifies the programming
process and allows the user to save configuration files
for later use.
The PROPLUS EX software requires the YPPA8068
USB Serial Adapter to connect the PC to the meter.
To download the PROPLUS EX programming
software, visit www.yokogawa.com/us.
16
Instruction Manual