Observable Problems - Lenovo ThinkSystem SD530 V3 User Manual

• "Cannot wake server using Wake on LAN" on page 224
• "Could not log in using LDAP account with SSL enabled" on page 224
Cannot wake server using Wake on LAN
Complete the following steps until the problem is resolved:
1. If you are using the multi-port network adapter and the server is connected to the network using RJ-45
connector, check the system-error log (see
a. The room temperature is not too high (see
b. The air vents are not blocked.
c. The air baffle is installed securely.
2. Reseat the multi-port network adapter.
3. Turn off the server and disconnect it from the power source; then, wait 10 seconds before restarting the
server.
4. If the problem still remains, replace the multi-port network adapter.
Could not log in using LDAP account with SSL enabled
Complete the following steps until the problem is resolved:
1. Make sure that the license key is valid.
2. Generate a new license key and log in again.

Observable problems

Use this information to solve observable problems.
• "Server hangs during the UEFI boot process" on page 224
• "The server immediately displays the POST Event Viewer when it is turned on" on page 225
• "Server is unresponsive (POST is complete and operating system is running)" on page 225
• "Server is unresponsive (POST failed and cannot start System Setup)" on page 225
• "Voltage planar fault is displayed in the event log" on page 226
• "Unusual smell" on page 226
• "Server seems to be running hot" on page 226
• "Cannot enter legacy mode after installing a new adapter" on page 226
• "Cracked parts or cracked chassis" on page 227
Server hangs during the UEFI boot process
If the system hangs during the UEFI boot process with the message UEFI: DXE INIT on the display, make sure
that Option ROMs were not configured with a setting of Legacy. You can remotely view the current settings
for Option ROMs by running the following command using the Lenovo XClarity Essentials OneCLI:
onecli config show EnableDisableAdapterOptionROMSupport --bmc xcc_userid:xcc_password@xcc_ipaddress
To recover a system that hangs during the boot process with Legacy Option ROM settings, see the following
Tech Tip:
https://datacentersupport.lenovo.com/solutions/ht506118
ThinkSystem SD530 V3 User Guide
224
"Event logs" on page 203), make sure:
Ambient temperature management).