Top View; Chassis Midplane - Lenovo ThinkSystem SD530 V3 User Manual

6 XCC system management port (10/100/1000 Mbps RJ-45)
The node has a 10/100/1000 Mbps RJ-45 connector dedicated to Lenovo XClarity Controller, which cannot
be accessed directly from the production network. A dedicated management network provides additional
security by physically separating the management network traffic from the production network. You can use
the Setup Utility to configure the node to use a dedicated systems-management network or a shared
network.
See the following for more information:
• "Set the network connection for the Lenovo XClarity Controller" on page 183
• "XCC system management port LEDs" on page 210

Top view

This following illustration provides information on the top view of the ThinkSystem SD530 V3 node.
Note: Depending on the specific configuration, the hardware might look slightly different from the
illustrations in this section.
Figure 7. Top view of SD530 V3
Table 13. Components on the top view
E3.S drive cage
1
E3.S drive backplane
2
DIMMs 1-8
3
Processor 1
4
Processor 2
5
DIMMs 9-16
6
Depending on the specific configuration, the node might not come with this component.
*
Note:

Chassis midplane

The following illustration shows the location and connectors of the chassis midplane.
ThinkSystem SD530 V3 User Guide
26
Power bus bar
7
Fans and fan cage
8
GPU air duct
9 *
PCIe riser assembly
10 *
Rear I/O module
11 *
Power distribution board
12