Fan Replacement - Lenovo ThinkSystem SD530 V3 User Manual

Figure 45. Installation of the drive cage assembly
After this task is completed
1. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see "Install the top cover" on page
2. Reinstall the node into the chassis (see
3. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
51.)
4. Proceed to complete the parts replacement (see

Fan replacement

Follow instructions in this section to remove or install the fans.
Remove a fan
Follow instructions in this section to remove a fan.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention: Read "Installation Guidelines" on page 41
sure that you work safely.
Procedure
Step 1. Make preparations for this task.
170).
"Install a node to the chassis" on page
"Install a hot-swap power supply" on page 61 and
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 42
.
Chapter 5 Hardware replacement procedures
75).
"Power on the node" on page
171).
to make
89