Pcie Riser Assembly And Adapter; Replacement - Lenovo ThinkSystem SD530 V3 User Manual

– Go to "Update the firmware" on page 185
• To avoid throttling, make sure to adopt passive Direct Attach cables when network adapters with 100GbE
or higher speed are installed.
Procedure
Step 1. If an OCP filler has been installed, remove it from the OCP slot.
Step 2. Install the OCP module.
a. Insert and push the OCP module into the slot until it is fully seated.
b. Tighten the thumbscrew to secure the OCP module.
Notes:
• If necessary, use a screwdriver for this step.
• Make sure to fully install the OCP module and securely tighten the thumbscrew. Otherwise,
the OCP module may not get full connection and may not function.
Figure 70. Installation of rear OCP module
After this task is completed
1. Power on the node (see
2. Proceed to complete the parts replacement (see
PCIe riser assembly and adapter replacement
Follow instructions in this section to remove or install the PCIe riser assembly and PCIe adapter.
Notes:
• Depending on the specific configuration, the node might not come with this component.
for more information on firmware updating tools.
"Power on the node" on page 51).
"Complete the parts replacement" on page
.
Chapter 5 Hardware replacement procedures
171).
115