Xerox WorkCentre XL2120 User Manual page 36

Customizing Your WorkCentre
Programmable Feature Settings 0 – 9 and 11 – 19
To change the programmable features, find the Program Number
and the desired Option Number in the Programmable features
chart on the following pages. Follow the instructions below.
Note: The WorkCentre must be off-line and in the Ready mode.
1. Select the Toner Saver mode.
2. Press again and hold the Auto Button (Image Quality) key for
approximately 4 to 6 seconds.
The light next to Auto mode will light.
The lights within the WorkCentre Diagram will flash.
3. Press the 10 key to select the Program Number of the feature
to be changed.
You will not be given the choice to change an option if
your machine does not have the feature.
4. Press Start.
The current setting for that program will flash.
5. Press the 1 key until the option number you want is displayed.
6. Press Start to store the selection.
7. Press the Clear key to continue making other changes.
Press the Image Quality key to return to the copy mode.
27