Programmable Features - Xerox WorkCentre XL2120 User Manual

Programmable Features

The default settings for various machine features may be
changed to suit your individual needs. All of these features
remain set until this process is repeated.
Each of the programmable features, along with its program
number and options are contained in the chart below. The
procedure to change the default settings follows the chart.
Note: The procedures written in this manual are based on the
factory default settings.
Feature
Priority Tray: This feature
allows you to set the default
paper tray. At power on or
auto clear, the copier will
return to the selected priority
paper tray.
(XL2140df)
Auto Clear Time Out: This
feature allows you to select the
time it takes for the copier to
return to the normal copy
mode after a copy cycle is
complete.
Time Out to Power Saver:
Temperature of the fusing
unit in this mode is lower
than in the Ready mode.
Fan speed is reduced.
Return to Ready mode at
the press of Start button
Time Out to Power Shut-Off:
Lowest power mode
Fuser and fans are off
Return to Ready mode at
press of Start button
Default Magnification: This
feature allows you to make
copies slightly larger or smaller
than the original, or the same
size.
Program Option Number
Number * Factory Setting
0 0 – Main paper tray *
1 – Alternate paper tray
2 – Second paper tray
1 0 – Off
1 – 30 seconds
2 – 60 seconds *
3 – 90 seconds
4 – 120 seconds
2 0 – Off
1 – 45 seconds
2 – 90 seconds *
3 – 2 minutes
4 – 5 minutes
3 Prog # Option
0 – 15 minutes
1 – 30 minutes*
2 – 60 minutes
3 – 90 minutes
4 – 120 minutes
5 – 240 minutes
4 0 – 100% *
1 – 99%
2 – 101%
29