Xerox WorkCentre XL2120 User Manual page 15

Installation
(continued)
6
Follow the steps below to properly set up your Xerox
WorkCentre.
1. Remove the bag from the WorkCentre.
2. Remove the pieces of tape A, B, C, D, and the packing
material E.
Remove the tape and the packing material supporting the clear
plastic 2-sided tray.
NOTE: To ensure the 2-sided tray is in the correct position,
gently push it in the direction shown by the arrow.
3. Open the Document Cover and remove the packing materials
shown.
NOTE: The XL2130f and XL2140df have a single piece of
packing material.
4. Unscrew and remove the Shipping Screw from the left side of
the WorkCentre. See step 6 for securing the Shipping Screw.
CAUTION: If the Shipping Screw is not removed, the
WorkCentre will malfunction and an L1 status code will be
displayed.
5. Lift and pull open the Paper Tray. Turn and remove the
Paper Tray lock. See step 6 for securing the Paper Tray
Lock.
CAUTION: Paper will misfeed if the Paper Tray lock is not
removed.
Note: Be sure to remove the Paper Tray Lock from both Paper
Trays.
XL2140df only
XL2140df only