Environmental Specifications; Space Requirements; Controller Placement - Xerox DocuPrint 100 Installation Planning Manual

Environmental specifications

Space requirements

Controller placement

Installation Planning Guide
earth is 200 to 240 VAC. The voltage between the other
supply pin and earth is less than 3 VAC.
Refer to the controller electrical requirements table earlier in this
chapter for a description of the power specifications for the
controller.
WARNING: To reduce the risk of electrical shock, do not plug
components into any other type of power system. Contact your
facilities manager or a qualified electrician if you are not sure what
type of power is supplied to your work area.
The controller is a sturdy piece of equipment; however, like any
piece of electronic equipment, it must be treated properly. Avoid
extremes in temperature and other environmental hazards. Place
the controller in a relatively dust-free area that is well-ventilated to
avoid overheating.
In general, if your working environment is comfortable for you, it is
suitable for your controller. The following sections define the
acceptable environmental ranges for the controller models with
which your system may be configured.
For recommended environmental ranges for the printer work area,
refer to the "Printer specifications and requirements" chapter of
this guide.
This section provides recommendations for placement of
controller hardware components.
For printer component space requirements, refer to the "Printer
specifications and requirements" chapter of this guide. Contact
your service representative if you have questions not specifically
addressed in this guide.
WARNING: The controller must be positioned within the line-of-
sight of the printer for safety purposes while servicing the
equipment.
The controller components are placed in the accompanying
controller stand. You should consider the following factors when
deciding where to place the controller and stand:
• There should be at least 36 inches / 15.2 cm of clearance on
Controller requirements and specifications
5- 3