Client Workstations And System Software - Xerox DocuPrint 100 Installation Planning Manual

Product overview

Client workstations and system software

1- 4
NOTE: It is the responsibility of the customer to supply, install, and
maintain hardware and software on any PC, Sun workstation, or
Macintosh workstation that is used to generate documents for
printing on the DocuPrint 100/115/135/155/180 EPS. You are also
responsible for obtaining, installing, and maintaining the required
Ethernet local area network, transceivers, bus and tag cables, and
any other connecting cables.
The Xerox DocuPrint 100/115/135/155/180 EPS prints LCDS data
from a mainframe host computer, emulating an IBM 4245 or 3211
line printer. The printing system can receive data over a channel
through bus and tag cables and through the Socket Gateway or lpr
using TCP/IP protocol.
Table 1-2
Throughput speed
Maximum
Printing
throughput
system
DP100 EPS 100 ppm
DP115 EPS 115 ppm
DP135 EPS 135 ppm
DP155 EPS 155 ppm
DP180 EPS 180 ppm
NOTE: Maximum throughput speed with 7 by 10 inch / 178 by 254
mm paper requires the 7 by 10 inch enablement kit.
Xerox is responsible for the physical installation and service of the
printer and controller hardware and software components. You
have the general responsibility for the site of ensuring that the
correct personnel, supplies, and network hardware and software
are available. Refer to the "Preparing for installation" chapter for a
detailed description of the shared responsibilities of the customer
and of Xerox.
To submit print jobs to the printing system, the customer needs to
provide the proper client hardware as well as operating system
and network software.
Maximum throughput
speed with 7 by 10 inch/
speed 178 by 254 mm paper
100 ppm
115 ppm
154 ppm
155 ppm
206 ppm
Installation Planning Guide