Controller Interface Options; Online Interface - Xerox DocuPrint 100 Installation Planning Manual

Mouse
Display monitor
Diskette drive
Optional processor
components

Controller interface options

Online interface

Installation Planning Guide
The mouse is another main method of communicating with the
printer.
The 17-inch LCD monitor allows you to interact with the printer
and to monitor its interaction with the various components. During
a print job, printer error messages may display to notify you of any
unexpected conditions.
The external diskette drive plugs into the back panel of the
processor. Diskettes inserted into a diskette drive are used to
install fonts and to load files to, and back up files from, the internal
disk drive. The diskette drive uses industry standard 3.5 inch, 1.44
MB, double-sided, high-density diskettes.
The controller may be configured with any of the following optional
components:
• Connectivity board to enable Token Ring
• Channel interface board for channel connection to a host for
online LCDS printing
• One SCSI board to connect to an external tape drive
• Graphics board:
– PGx64 (Sun Blade 1000/2000)
– XVR-100 (Sun Blade 2500)
– Creator-3D series 3 graphics board
NOTE: The PGX64 graphics board is provided as a standard
feature of the processor. If more than one connectivity option is
installed, the PGx64 board is replaced by the Creator3D graphics
board.
Your printing system may be configured for either the online
interface, the offline interface, or both.
The online (channel-attached) interface receives input directly
from any environment that supports the IBM 3211 and 4245 host
systems.
Controller components and options
2- 9