Connection Procedure - Eizo LMM56800 Instructions For Use Manual

5.3 Connection procedure

Note
Picture quality, noise immunity, and emitted interference
Use high-quality cables only. The picture quality, noise immunity, and emitted interference
of the entire system depend on the cable quality and length.
Connecting the monitor and video sources
1. Install the DP modules (DisplayPort to DVI converter) on the LMM56800.
2. Connect the TDL Link Sets to the DP modules.
See also Installing and connecting the DP module.
3. Connect the monitor.
Note: To display the video sources correctly, the monitor has to support the output reso-
lution of the LMM56800: 3840x2160@60 Hz (8 MP).
4. Install the Y cables
See alsoInstalling the Y cable
5. Connect the video sources according to the following table.
PC video output
DVI
VGA
Connecting to the network
The LMM56800 operates using a network. A network connection has to be established be-
tween RJ45 connector N1 of the LMM56800 and a PC.
• Use commercially available network components for this purpose, such as network ca-
bles, network hubs, and switches.
• Contact your network administrator with any questions on the network connection.
LMM56800
Instructions for Use, 10/2019
[} 16].
LMM56800 video inputs (1 ... 27)
• If you assign connection panels 3 ... 8, 12 ... 17, 21 ... 25, use an HDMI-
DVI adapter cable.
• If you assign the connection panels 1, 10 and/or 19, use a commercially
available DVI cable.
• If you assign the connection panels 2, 9, 11, 18, 20, and/or 27, use a com-
mercially available VGA cable.
5.3 Connection procedure
[} 15].
Connecting
21