Setting Up Operation - Eizo LMM56800 Instructions For Use Manual

Large monitor manager

Hide thumbs Also See for LMM56800:

Table of Contents

Configuration and operation

6.3 Setting up operation

The LMM56800 operates via remote access. Remote access is possible via LAN or WLAN

The following steps are necessary to set up the connection:

Note

The Large Monitor Manager has to be switched on and connected to the network.

1. On the workstation, open the Internet protocol properties (TCP/IP) under Network set-

tings/Local network.

2. Check that the general settings for IP address and DNS server are set to "Obtain auto-

matically".

3. Under "Alternative configuration", set "User configured" and the following data:

IP: 169.254.213.96

Note: The address has to be in the address range 169.254.213.xxx and may not conflict

with other addresses. The Large Monitor Manager address is 169.254.213.44.

Subnet: 255.255.0.0

4. Confirm with "OK" and close the Network settings dialog window.

5. In the network settings for the browser, set "No proxy".

6. Confirm and close the browser settings with "OK".

7. Enter the IP address of the Large Monitor Manager in the browser address line:

"169.254.213.44/config"

ð The LMM56800 user interface is displayed and is ready for use.

You can now configure the LMM56800 through the network and make the network set-

tings as specified by the local administrator. This may require changes to the workstation

IP address settings. In this case, follow the steps above.

Note

During operation via remote access, windows are identified by their corresponding thumb-

nail, live images are not transmitted.

LMM56800

Instructions for Use, 10/2019

Table of Contents