Mitsubishi MELSEC F FX-40DU-E Handy Manual page 99

7.
EDIT MODE
r
I
Editing Objects for Individual Screen Settings
(c) DEV. (device)
Possible settings: bit devices (X, Y, M, S, T. C)
Press the [
0 ]
key to display the menu shown below at the bottom of the screen; devices can
then be specified.
/ I
Use
[
V,
A ]
keys to select the device
type.
.IY
Y
S T C ; : 2 V
A V - ,
F]
Use l o t 0 9 ] keys to input the device number.
ENTER
Use
[ENTER]
key to confirm the selection.
El
Note:
.
I f a word device is selected the error message "SET DEVICE IS INCORRECT" will be
displayed. This message can be cleared by pressing the [CLEAR] key, after which an
acceptable device can be input.
(d) ACTIVE
Specify whether the device set in (c) is active when ON or active when OFF.
WHEN ON: Display highlighted when the device specified in (c) goes from OFF to ON.
WHEN OFF: Display highlighted when the device specified in (c) goes from ON to OFF.
(e) Registration
When all settings are completed the message SETTING? will be displayed. If the setting is
correct, press the [ENTER] key at OK to register it.
However, if the error message "SETTING IS INCORRECT" is displayed, clear the error
message by pressing the [CLEAR] key and then check for a mistake in the position and Size
settings.
Select CANCEL to start the modification procedure again from the POS. setting.