Mitsubishi MELSEC F FX-40DU-E Handy Manual page 97

7.
EDIT MODE
(c) DEV. (device)
Possible settings: word devices (T, C, D 16-bit, D 32-bit, Z, V)
Press the [
0
] key to display the menu shown below at the bottom of the screen; devices
can then be specified.
( 1
Use [
r,
A ]
keys to select the device type.
r ~ V M S T C D D ~ Y
lb
s
A P - i
Use
10
-
9
]
keys to input the device number.
ENTER
Use
[ENTER]
key to confirm the selection.
D
Note:
-
I f a bit device is selected ihe error message "SET DEVICE I S INCORRECT" will b e
displayed. This message can be cleared by pressing the [CLEAR] key, after which an
acceptable device can be input.
(d) TYPE
Horizontal or vertical.
(e) Maximum value, minimum value
Sets the minimum and maximum value for the current value and setting value of the selected
device.
(Settings within a 32-bit data range)
(f) Registration
When all settings are completed the message SETTING? will be displayed. If the setting is
correct, press the [ENTER] key at OK to register it.
However, if the error message "SETTING IS INCORRECT" is displayed, clear the error
message by pressing the [CLEAR] key and then check for a mistake in the position and size
settings.
Select CANCEL to start the modification procedure again from the POS. setting.