Table of Contents
Advertisement
7.
EDIT MODE
(6)
LAMP (EXT)
Described here is the procedure for modifying a LAMP (EXT) object. After selecting the LAMP
(EXT) object to be modified,, select MODIFY OBJECT; the screen shown below will be displayed.
ixample TEXT modification soreen
OUTPUT :
EXT 00
DEV. :
M
D
ACTIVE : WHEN ON
BASIC OPERATION
I
Select object to
be
modified
V, A
ENTER
OUTPUTsettimg
(a)
0
V,
A
Device No.
DEV.
setting (b)
V,
A
ENTER
Returnto
WTPUT setting
ACTIVE selling (c)
ENTER
OK
The range of possible settings for each item is described below.
(a) OUTPUT
Specifiy the external output that will respond to the signal from the device specified in (b) below.
[EXT 001 to [EXT 071
(b) DEV. (device)
Possible settings: bit devices (X,
Y,
M. S, T, C)
Press the [ 0 ] key to display the menu shown below at the bottom of the screen; devices can
then be specified.
(c) ACTIVE
r ~ ~ M s r c D D z v
r a - 1
$6
S
Specify whether the device set in (b) is active when ON or active when OFF.
Use [
r,
A
1
keys to select the device
type.
WHEN ON: Display highlighted when the device specified i n (b) goes from OFF to ON.
WHEN OFF: Display highlighted when the device specified in (b) goes from ON to OFF.
Po/
Use [ D
to
91
keys to input the device number.
/ I
Use [ENTER] key to confirm the selection.
Note:
If a word device is selected the error message "SET DEVICE I S INCORRECT" will be
displayed. This message can be cleared by pressing the [CLEAR] key, after which an
acceptable device can be input.
(d) Registration
When all settings are completed the message SETTING? will be displayed. If the setting is
correct, press the [ENTER] key at OK to register it.
However, if the error message "SETTING IS INCORRECT" is displayed, clear the error
message by pressing the [CLEAR] key and then check for a mistake in the position and size
settings. Select CANCEL to start the modification procedure again from the POS, setting.
Advertisement
Table of Contents
Troubleshooting
