Mitsubishi MELSEC F FX-40DU-E Handy Manual page 95

7 . EDIT MODE
(c) DEV. (device)
Word devices (T, C, D 16-bit, D
32
bit, Z. V)
Press the [
0
] key to display the menu shown below at the bottom of the screen; devices can
then be specified.
/ ] U s e [ V, A ] keys to select the device type.
v E ( v . s r c D O z v
38
s
I
r]
Use [ 0
-
99 keys to input the device
number.
/ I
Use
[ENTER] key to
confirm the selection.
Note:
.
I f a bit device is selected the error message "SET DEVICE IS INCORRECT" will be
displayed. This message can be cleared by pressing the [CLEAR] key, after which an
acceptable device can be input.
(d) DIGIT (total number of digits)
1 to 12. Note that the decimal point and minus sign are each counted as one digit.
(e) Maximum value, minimum value
Set the minimum and maximum value for the current value and setting value of the selected
device. (Settings within a 32-bit data range)
(f) Registration
When all settings are completed the message SETTING? will be displayed. If the setting is
correct, press the [ENTER] key at OK to register it.
However, if the error message "SETTING IS INCORRECT" is displayed, clear the error
message by pressing the [CLEAR] key and then check for a mistake in the position and size
settings.
Select CANCEL to start the modification procedure again from the POS. setting.