7.
EDIT MODE
Editing Objects for Individual Screen Settings
(c) ATTR. (character attribute)
Set to determine whether the characters are displayed normally or highlighted.
(d) DEV. (device)
Word devices (T, C, D 16-bit)
Press the [
0 ]
key to display the menu shown below at the bottom of the screen; devices can
then be specified.
1
V,
A
/
Use [ V ,
A
] keys to select the device type.
r m v u s r c n 0 2 v
l b
s
A B
I
( 1
Use
[ 0
-
9 1 keys to input the device number.
-
E l
Use [ENTER] key to confirm the selection
Note:
.
I f a bit device is selected the error message "SET DEVICE I S INCORRECT" will be
displayed. This message can be cleared b y pressing the [CLEAR] key, after which an
acceptable device can be input.
(e) WORD (number of word devices)
1 t o 12. Note each word device can hold 1 x 16 bit character or 2 x
8
bit characters.
(f) Registration
When all settings are completed the message SETTING? will be displayed. If the setting is
correct, press the [ENTER] key at OK to register it.
However, if the error message "SETTING IS INCORRECT" is displayed, clear the error
message by pressing the [CLEAR] key and then check for a mistake in the position and size
settings.
Select CANCEL to start the modification procedure again from the POS, setting.