Replacing magnet
1. Perform general disassembly (see page 26).
2. Remove extraction head (see page 43).
3. Remove screws (b) and bracket (34).
4. Put on gloves.
Do not touch the surface of the magnet (28) and the metal plate (a)! Otherwise
the alignment between the two components will not work properly.
5. Pull out magnet (28) by using a screwdriver.
Assembly tips
1. Put on gloves.
Do not touch the surface of the magnet (28) and the metal plate (a)! Otherwise
the alignment between the two components will not work properly.
2. Insert new magnet (28) into socket.
3. Press and hold metal plate (a) on magnet (28) so that they are well aligned.
4. Check that magnet (28) is in bottom position.
5. Assemble bracket (34) with screws (b).
R E P A I R
Service manual
47