Table of Contents
Advertisement
Replacing power cord with thermo fuses
1. Perform general disassembly.
2. Loosen two screws and remove strain relief (n).
3. Pull power cord (11) out of cable duct in base plate.
4. Remove thermoblock (9) with support (10) see large detail:
Release retention latch of support at the base plate with a screwdriver (red circle).
Push hooks beside retention latch in direction shown with a screwdriver and
remove thermoblock support.
.
5. Loosen screw (18) and remove fuse holder clip (17) with ground connection (p) and
thermo fuses (q) from thermoblock (9).
R E P A I R
Service manual
35
Advertisement
Table of Contents
