Advertisement
e After the crankcase
bolts have been tightened,
check
if driveshaft
and
countershaft
rotate
smoothly.
e |f a large resistance
is felt to rotation, try to
free
the
shafts
by tapping
the
driveshaft
or
countershaft with a plastic hammer as shown in
the Fig.
CAM
DRIVEN
GEAR
e Install
the
gear shifting
pawls
into
the
cam
driven gear. The large shoulder (A) must face to
the outside as shown in the illustration.
e When
installing
the
cam
guide (and
pawl
lifter@, apply a small quantity of THREAD
LOCK "1342" to the securing screws (3) .
| 99000-32050
Thread lock ''1342"
GEARSHIFT
SHAFT
e
Fit a spring to the gearshift shaft correctly.
e Install
the
gearshift
shaft.
Match
the
center
teeth of the gear on the gearshift shaft with the
center teeth on the cam driven gear as shown.
NOTE:
When replacing the gearshift arm stopper (8),
apply a small quantity
of THREAD
LOCK
SUPER
"1303"
to the threaded
part of the
stopper and tighten it to the specified torque.
(See page 7-18)
e
Fit the
gearshift
cover
and tighten
the bolts
NOTE:
After the gearshift cover and gearshift lever
have been fitted, confirm that gear change is
normal
while
turning
the countershaft and
driveshaft.
If gear change is not obtained, it
means that assembly of gears or installation of
gearshift fork is incorrect. If this is the case,
diagonally.
GASKET
!!1485
-!2800
disassemble and trace the mistake.
Advertisement
