Advertisement
341 SERVICING ENGINE
DRIVESHAFT
DISASSEMBLY
e After removing
the
Low
driven
gear and Top
driven gear, remove the 3rd driven gear circlip
@® from the groove and slide circlip toward the
4th driven gear @).
09900-06104
Snap ring pliers
Then, remove
the 3rd driven gear by removing
the lock washers, @) and @.
09900-06107
Snap ring pliers
NOTE:
a Always use new circlips.
[ NOTE:
CAUTION:
*
*
+
When installing a new circlip, care must be
taken
not
to expand
the end
gap larger
than required
to slip the circlip over the
shaft.
After installing a circlip, always insure that
it is completely
seated
in its groove and
securely fitted.
—
Thrust
Sharp edge
Advertisement
