Advertisement
SERVICING ENGINE 3-8
e Install the oil cooler hoses ( (1) and
()) to the
clutch cover correctly as shown in Fig.
@® "UPPER" Oil cooler hose
@ "LOWER" Oil cooler hose
20 — 25 N-m
Tightening torque
( 2.0 — 2.5 kg-m
)
14.5 — 18.0 Ib-ft
e When
installing the brake pedal, be sure to align
the punched marks.
@ The engine sprocket should be installed on the
driveshaft
as shown
in the figure at the same
time of the installation of drive chain. If it is
difficult
to
assemble
the
engine
sprocket,
remove
the rear axle *cotter pin and loosen the
axle
nut to push
the rear wheel
forward, and
give the drive chain some play. When
installing
the engine sprocket lock washer, turn it to fit
into
the groove.
After
completing
tightening
of the engine mounting bolts, adjust free play of
the drive chain.
(See page 2-12)
(* Canada model only)
TIGHTENING TORQUE
ITEM
;
Ib-ft
Engine sprocket mounting bolt
Ki
i
3.0 — 5.0
Rear axle nut
Dyk
;
i
36.0 — 58.0
Advertisement
