Advertisement
CHASSIS 6-2
INSPECTION
WHEEL HUB BEARING
Inspect
the play of the wheel
hub bearing inner
race by hand while it is in the wheel hub.
Rotate
the
inner
race
by hand
to
inspect
for
abnormal noise occurs and rotating smoothly.
Replace the bearing if there is anything unusual.
AXLE SHAFT
Using a dial gauge, check the axle shaft for runout
and replace it if the runout exceeds the limit.
09900-20606
Dial gauge (1/100)
09900-20701
Magnetic stand
TIRE
For proper
braking
and
riding stability,
the tire
should have sufficient groove depth from the tread
surface. If the groove depth, measured as shown in
the figure, reaches the wear limit, replace the tire.
]
Service Limit
|
3.0 mm (0.12 in)
WHEEL RIM
Make sure that the wheel
rim runout checked as
shown, does not exceed the service limit. An ex-
cessive
runout
is usually
due to worn
or loose
wheel hub bearings and can be reduced by replacing
the bearings. If bearing replacement fails to reduce
the the runout,
adjust the tension of the spokes
and, if this proves to be of no effect, replace the
wheel rim.
Service Limit
2.0 mm (0.08 in)
(Axial and Radial)
Play
Play
Advertisement
