Figure 105. Installing the LOM riser card
Next steps
1.
Replace the expansion card
2. If removed,
replace the rear drive
3.
Install the air
shroud.
4. Follow the procedure listed in
Storage controller card
Removing the mini PERC card air shroud
Prerequisites
CAUTION:
Never operate your system with the air shroud removed. The system may get overheated, resulting in
shutdown of the system and loss of data.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable,
remove the rear drive
5. If applicable,
remove the expansion card
NOTE:
Never operate the system with the air shroud removed. The system may get overheated quickly, resulting in
shutdown of the system and loss of data.
Steps
1. Remove the screw securing the mini PERC card air shroud to the system board.
riser.
cage.
After working inside your system
Safety instructions
Before working inside your system
cage.
riser.
on page 27.
on page 26.
on page 27.
Installing and removing system components
99