Figure 62. Installing the front mounting front PERC module
Next steps
1. Reconnect all the required cables.
2. If removed,
install the air
3. Follow the procedure listed in
Removing the PERC card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
Steps
1. Using Phillips #2 screw driver, remove the two screws.
2. Hold the metal holder and slide it toward the PSU, then take it out of the chassis.
3. Disconnect the cable.
68
Installing and removing system components
shroud.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.