Table of Contents
Advertisement
f.
Intrusion switch
g.
Internal USB key (if installed)
h.
Processor heat sink module
i.
Memory modules
j.
OCP if installed
k. Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board
from the system.
Steps
1. Using the system board holder, slide the system board toward the front of the chassis.
2. Hold and pull the plunger that is located on system board and lift the system board out of the chassis leaning at an angle.
Figure 127. Removing the system board
Next steps
Replace the system
board.
Installing the system board
Prerequisites
NOTE:
Before replacing the system board, replace the old iDRAC MAC address label in the Information tag with the iDRAC
MAC address label of the replacement system board
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If you are replacing the system board, remove all the components that are listed in the
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
removing the system board
section.
159
Advertisement
Table of Contents
