Figure 99. Removing the BOSS-N1 module cover
Next steps
1.
Replace the BOSS-N1 controller card module.
Installing the BOSS-N1 controller card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Slide the BOSS cover on the BOSS-N1 controller card module. Using the Phillips #1 screwdriver, secure the BOSS cover on
the BOSS-N1 controller card module with the M3 x 0.5 x 4.5 mm screw.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
135