Table of Contents
Advertisement
Figure 95. Removing the BOSS-N1 card carrier
3. Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card
carrier.
4. Slide the M.2 SSD out and up from the BOSS-N1 card carrier.
Figure 96. Removing the M.2 SSD
5. Disconnect the BOSS power cable and BOSS signal cable from the system board. Using the Phillips #1 screwdriver remove
the two M3 x 0.5 x 4.5 mm screws that secure the BOSS-N1 controller card module on the BOSS module bay. Slide the
BOSS-N1 controller card module out from the BOSS module bay.
Installing and removing system components
133
Advertisement
Table of Contents
