Table of Contents
Advertisement
Figure 59. Installing the drive backplane
Next steps
1. Reconnect all the disconnected cables to the backplane.
2.
Install all the drives.
3.
Install the drive backplane
4.
Install the air
shroud.
5. Follow the procedure listed in
Cable routing
Figure 60. Cabling diagram of configuration 1 - 16 x 2.5-inch SAS/SATA + 8 x 2.5-inch NVMe drive backplane
configuration with rear mounted fPERC (PERC11), riser 1C with dual processor configuration
cover.
After working inside the
system.
Installing and removing system components
99
Advertisement
Table of Contents
