Configuring and Validating Smart Licensing
Configuring Smart License Seats Management using CLI
To configure a smart license seat, use the following CLI command:
Device# license iw-network platform [ iw9165 | iw9167 ] seats
Example:
Device# license iw-network platform iw9165 seats 12
Device# license iw-network platform iw9167 seats 15
Configuring Running License Level using CLI
The license level, for Catalyst IW916x devices, is configured by the primary Mesh End (ME) or GGW gateway
(based on network configuration) then the license level applied to all the gateways connected to the network.
To configure a license level for ME and GGW (license distributor), use the following CLI command:
Device# license iw-level [ advantage | essentials | premier ]
advantage
essentials
premier
The license level for IEC-6400 devices needs to be configured on each IEC device.
To configure a license level for an IEC device, use the following CLI command:
Device# license iec-level
advantage
essentials
premier
Verifying License Smart License Seat using CLI
To verify the configured smart license seat, use the following CLI command:
Device# show license iw seats
Platform Configured Current
IW9167 0 15
IW9165 0 12
Device# write
Device# reboot
Device# license iw seats
Platform Configured Current
IW9167 0 15
IW9165 0 12
Configuring Running License Level for Gateway using CLI
To configure the license level for the gateway, use the following CLI command:
Device# license iec-level [ advantage | essentials | premier ]
advantage: Network Advantage for Radios
essentials: Network Essentials for Radios
premier: Network Premier for Radios
Network Advantage for Radios
Network Essentials for Radios
Network Premier for Radios
Network Advantage for Gateway
Network Essentials for Gateway
Network Premier for Gateway
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
Configuring Smart License Seats Management using CLI
49