Gateway In Provisioning Mode; Gateway In Disconnected Mode - Cisco IEC6400 Installation And Configuration Manual

Gateway in Provisioning Mode

Gateway in Provisioning Mode
The gateway is in provisioning mode if the status is shown as Provisioning.
Alternatively, if the status of IoT OD IW is shown as Online or Offline, you must choose between two further
options:
• To configure the gateway as a new gateway, revert the gateway to provisioning mode and reset the
• To change the connection settings with the current configuration, see
To verify if the gateway is in provisioning mode, use the following CLI command:
Device# iotod-iw show status
IOTOD IW mode: Provisioning
Status: Connected

Gateway in Disconnected Mode

If the gateway is in provisioning mode, IoT OD IW status is shown as:
When the gateway fails to receive an IP address from the DHCP server, it reverts to the fallback IP address
(192.168.0.10/24).
Note
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
24
gateway, see Resetting the Gateway to Factory Default using
GUI.
DHCP is only used in provisioning mode. A static IP address must be assigned for normal operation.
Configuring the Gateway Initially in Provisioning Mode
GUI.
Configuring General Settings using