Uploading a Saved Configuration File to the Gateway
Uploading a Saved Configuration File to the Gateway
To upload the saved configuration file on to the gateway, follow these steps:
Before you begin
Before initiating the restoration process using the configuration file, ensure you have the file stored on your
computer. For downloading the file, see
Step 1
In the MANAGEMENT SETTINGS, click configuration settings.
The LOAD OR RESTORE SETTINGS window appears.
Step 2
Click Browse to upload the configuration (*.conf) file.
The selected configuration file is shown next to the Browse button.
Step 3
Click Restore to apply the configuration settings to the gateway.
Once you apply the configuration, the gateway starts rebooting.
Configuring IoT OD IW Online and Offline Mode using CLI
To configure the gateway using IoT OD IW, use the following CLI command:
Device# iotod-iw configure {offline | online}
Online – It sets up IoT OD IW to online mode. The gateway can be managed from an IoT OD IW cloud server.
Offline – It sets up IoT OD IW in offline mode. The gateway is disconnected from IoT OD IW and must be
manually configured.
To configure the gateway using IoT OD IW, see
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
32
Configuring the Gateway Initially in Provisioning Mode
Downloading the Gateway's Current Configuration
Configure IW gateways in online / offline
Settings.
mode.