Cisco IEC6400 Installation And Configuration Manual page 47

Configuring Advanced Settings
Parameter
Port mode (all Ethernet ports)
Traffic Management
The incoming data packets are classified based on the following parameter values:
Parameter
Signaling
User
Packet tagged with MVID
Access port rules for incoming packets
Untagged packet from the gateway
Untagged packet with VLAN ID (VID) is not
configured
Untagged packet with VID is configured
Tagged packet with valid VID
Tagged packet with null (0) VID
Access port rules for outgoing packets
Tagged packet with configured and allowed VID
Packet from the gateway
Tagged packet with VID is not configured
Parameter
Tagged packet with valid VID, but not allowed
Tagged packet with null (0) VID
Access port rules management for incoming packets with a gateway in smart mode
Untagged packet
Tagged packet (any VID without any check)
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
Rules for Packet Management
Default value
Smart
Default value
Ethernet protocol type
All other traffic
Packet allowed
Packet allowed
Packet allowed
Packet tagged with specified VID
Packet dropped
Packet dropped
Packet allowed
Packet allowed
Packet allowed
Default value
Packet dropped
Packet dropped
If native VLAN is ON, then the packet is allowed
(tagged with NVID)
If native VLAN is OFF, then the packet is dropped
Packet allowed with original tag
41