Table of Contents
Advertisement
Log into Gateway Configurator for the First Time
Before you begin
After your initial login, the configurator prompts you to change the gateway's login credentials and mesh
passphrase. You can perform this task using either of the following methods:
Configuring New Login Credentials using GUI
To change the login credentials, follow these steps:
Step 1
Enter the current username in the Current username field.
Step 2
Enter the current password in the Current password field.
Step 3
Enter the new username in the New username field.
Step 4
Enter the new password in the New password field. For rules on creating the new login credentials, see
the Login
Credentials.
Step 5
Re-enter the new password in the Confirm new password field.
Step 6
Enter the current mesh passphrase in the Mesh passphrase field.
Step 7
Enter the new mesh passphrase in the Confirm mesh passphrase field.
Step 8
Click Change.
The IEC-6400- URWB Configurator window appears.
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
Configuring New Login Credentials using GUI
Rules to Reset
17
Advertisement
Table of Contents
