Table of Contents
Advertisement
Log into Gateway Configurator for the First Time
• Example of configuring a password from the CLI:
Device# # iotod-iw configure offline
Switching to IOTOD IW Offline mode...
Step 3
After the first login, reset your credentials:
Old username:Cisco
Old Password:Cisco
New username:demouser
New Password:DemoP@ssw0rd
Confirm Password:DemoP@ssw0rd
Mesh Passphrase:
Confirm Mesh Passphrase:
YES
Step 4
After successful credentials change, login again:
User access verification
Username: demouser
Password: DemoP@ssw0rd
In the above example, all passwords are in plain text. This is for demo purposes (example credential). In the
Note
actual configuration, they are hidden behind asterisks (*).
Rules to Reset the Login Credentials
When the gateway is switched to offline mode (after the initial login), you need to set a new login credential
for the gateway. To configure a new password using a GUI or CLI, the login credentials should follow the
criteria:
• The username length must be from 1 to 32 characters.
• The password length must be from 8 to 32 characters.
• The password must include at least one uppercase character, one lowercase character, one digit, and one
• The following special characters are permitted:
special character.
• ! (Exclamation mark)
• * (Asterisk)
• + (Plus sign)
• - (Minus sign)
• , (Comma)
• ‐ (Hyphen)
• @ (At sign)
• ^ (Circumflex)
• _ (Underscore)
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
Rules to Reset the Login Credentials
19
Advertisement
Table of Contents
