Configuring Advanced Settings; Configuring Snmp Using Cli - Cisco IEC6400 Installation And Configuration Manual

Configuring Advanced Settings

•
•
•
•
•
•
•
•
•
•

Configuring SNMP using CLI

URWB software for network management functionalities uses SNMP applications. The SNMP implementation
supports queries (solicited) and traps (unsolicited). If you enable SNMP traps, specify the server address to
which the monitoring information is sent.
Note
To configure SNMP, use the following CLI commands:
Note
Table 1: SNMP CLI Commands
Purpose
To enable or disable SNMP functionality
To specify the SNMP protocol version
Configuring SNMP using CLI, on page 33
Configuring SNMP Version v2c using GUI, on page 35
Configuring SNMP Version v3 using GUI, on page 35
Configuring NTP using GUI, on page 37
Configuring NTP using CLI, on page 38
Configuring VLAN Settings, on page 40
Rules for Packet Management, on page 40
Configuring Fluidity Settings using GUI, on page 42
Configuring Fluidity Settings using CLI, on page 43
Configuring Gateway Status, on page 43
The same SNMP configuration must be set for all gateways in the network.
All parameters of SNMP are required to be configured before enabling SNMP feature using CLI:
snmp enabled
Cisco IEC6400 Edge Compute Appliance Installation and Configuration Guide, Release 1.0.0
6
C H A P T E R
Command or Action
Device# snmp [enabled | disabled]
Device# snmp version {v2c | v3}
33